Hyundai Tucson: Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the HO2S connector.

3.	Measure resistance between the HO2S terminals 2 and 5 [B1/S1].

4.	Measure resistance between the HO2S terminals 3 and 4 [B1/S2].

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

[Bank 1 / Sensor 1]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

Disconnect the connector (A), and then remove the sensor (B).

Note that the SST (Part No.: 09392-1Y100 or 09392-2H100) is useful when removing the heated oxygen sensor.

[Bank 1 / Sensor 2]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the console side cover (A).

Disconnect the connector (A), and then remove the sensor (B).

Note that the SST (Part No.: 09392-1Y100 or 09392-2H100) is useful when removing the heated oxygen sensor.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.

•	Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).

Install in the reverse order of removal.

Heated oxygen sensor installation:

39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

Heated Oxygen Sensor (HO2S) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Rail Pressure Sensor (RPS) Description and Operation

Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil Pump Repair procedures
Removal and Installation 1. Remove the timing chain cover. (Refer to Timing system in this group) 2. Remove the oil pump cover (A). Tightening torque Screws : 5.9 ~ 8.8 N.m (0.6 ~ 0.9 kgf.m, 4.3 ~ 6.5 lb-ft) Bolts : 8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft) 3. Remove ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Display Settings
Press the key Select [Display] through TUNE knob or key Select menu through TUNE knob Mode Pop up [Mode Pop up] Changes / selection mode During On state, press the or key to display the mode change pop up screen. Text Scroll [Text ...