Hyundai Tucson: Engine Control System / Rail Pressure Sensor (RPS) Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation

Description

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

Heated Oxygen Sensor (HO2S) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 2 and 5 [B1/S1]. 4. Measure resistance between the HO2S t ...

Rail Pressure Sensor (RPS) Specifications

Specification ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Removal 1. Remove the liftgate trim in the trunk after removing the screws and clips. (Refer to the BD group - "Liftgate") 2. Remove the liftgate garnish (A) after disconnecting the connector and removing the nuts. 3. Remove the back view camera (A) after loosening the screws (2EA). ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil level sensor Repair procedures
Removal and Installation [For Europe] When the oil sensor signal fault occurs, refer to the DTC guide. 1. Drain the engine oil. 2. Remove the oil level sensor (A) after disconnecting the oil level sensor connector. Tightening torque: 8.8 ~ 9.8N.m (0.9 ~ 1.0kgf.m, 6.5 ~ 7.2lb-ft) ...