| Removal |
The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag. |
| 1. |
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. |
| 2. |
Remove the front seat assembly. (Refer to the Body group- Seat) |
| 3. |
Remove the seat back assembly. (Refer to the Body group- Seat) |
| Installation |
Be sure to install the harness wires not to be pinched or interfered with other parts. |
|
| 1. |
Remove the ignition key from the vehicle. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Install the new seat back assembly.
(Refer to the Body group - Seat) |
| 4. |
Install the front seat assembly.
(Refer to the Body group - Seat) |
| 5. |
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts. |
| 6. |
Reconnect the battery negative cable. |
| 7. |
After installing the side airbag (SAB), confirm proper system operation:
|
Side Airbag (SAB) Module Components and Components Location
Curtain Airbag (CAB) Module Description and OperationHyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Inspection
Manual Transaxle Oil Inspection
1.
Park the vehicle on a level ground and stop the engine.
2.
Retighten the oil filler plug (A) with a new washer.
3.
Check level with finger.
Oil level must be up to fill the hole, if not, add oil until it runs over.
...
Hyundai Tucson (LM) 2010-2015 Service Manual: Driver Airbag (DAB) Module and Clock Spring Description and Operation
Description
Driver Airbag (DAB) is installed in the steering wheel and
electrically connected to SRSCM via the clock spring. It protects the
driver by deploying the airbag when frontal crash occurs. The SRSCM
determines deployment of the Driver Airbag (DAB).
Never att ...