Hyundai Tucson: Wiper blades / Blade inspection
Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers.
Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a clean cloth dampened with washer fluid.
CAUTION
To prevent damage to the wiper blades, arms or other components, do not:
- Use gasoline, kerosene, paint thinner, or other solvents on or near them.
- Attempt to move the wipers manually.
- Use non-specified wiper blades.
✽ NOTICE
Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean.
Wiper blades
...
Blade replacement
Front windshield wiper blade
■ Type A
1. Raise the wiper arm and slightly rotate the wiper blade assembly to expose
the plastic locking clip.
CAUTION
Do not allow the wiper arm to fall aga ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal waveform
This example shows a typical Crankshaft Position Sensor(CkPS)
and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls
the injection and ignition timing by using these signals.
Generally CkPS signal is used to detect the piston's position
and CMPS signal is use ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Oil level sensor Repair procedures
Removal and Installation
[For Europe]
When the oil sensor signal fault occurs, refer to the DTC guide.
1.
Drain the engine oil.
2.
Remove the oil level sensor (A) after disconnecting the oil level sensor connector.
Tightening torque:
8.8 ~ 9.8N.m (0.9 ~ 1.0kgf.m, 6.5 ~ 7.2lb-ft)
...