Hyundai Tucson: Seat belts / Care of seat belts

Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse.

Periodic inspection

All seat belts should be inspected periodically for wear or damage of any kind. Any damaged parts should be replaced as soon as possible.

Keep belts clean and dry

Seat belts should be kept clean and dry. If belts become dirty, they can be cleaned by using a mild soap solution and warm water. Bleach, dye, strong detergents or abrasives should not be used because they may damage and weaken the fabric.

When to replace seat belts

The entire seat belt assembly or assemblies should be replaced if the vehicle has been involved in an accident.

This should be done even if no damage is visible. Additional questions concerning seat belt operation should be directed to an authorized HYUNDAI dealer.

Do not lie down
Sitting in a reclined position when the vehicle is in motion can be dangerous. Even when buckled up, the protections of your restraint system (seat belts and air bags) is greatly reduced by reclini ...

Child restraint system
WARNING Always properly restrain children in the rear seats of the vehicle. Children of all ages are safer when restrained in the rear seat. A child riding in the front passenger seat can be forc ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Heater & A/C Control Unit(Dual) Components and Components Location
Components Control Panel Connector Pin Function ConnectorPin NOFunctionConnectorPin NOFunctionConnector(A)1BatteryConnector(B)1CAN (LOW)2Tail Lamp (ILL+)2CAN (HIGH)3IG23Intake Actuator (F/B)4DR Temp Actuator (COOL)4Mode Actuator (F/B)5DR Temp Actuator (WARM)5PS Temp Actuator (F/B)6-6DR Temp A ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Input Speed Sensor Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body") 2. Disconnect the input & output speed sensor conn ...

В© 2010-2026 www.htmanual.net