Hyundai Tucson: Engine Control System / Injector Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Injector Description and Operation

Description

The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the nozzle. This aids in atomization of the fuel.

The ECM controls both the feed circuits (high side) to feed voltage to the injectors and the ground circuits (low side) to energize the injectors. Also, the feed for 2 injectors comes from the same driver set. As the ignition coils are paired with cylinders (1-4 and 2-3), the injectors are also set up in pairs.

Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: Refer to "Specification" Removal 1. Turn the ignition swit ...

Injector Specifications

Specification ItemSpecificationCoil Resistance (x)1.5 [20°C(68°F)] ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at high temperature after vehicle running may be high or low. So all resistance must be measured at ambi ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Hood Repair procedures
Replacement Hood Assembly Replacement • When removing and installing the hood, an assistant is necessary. • Take care not to damaged the hood and body. • When removing the clips, use a clip remover. 1. Loosen the hood hinge (A) mounting bolts, re ...