Hyundai Tucson: Engine Control System / Fuel Tank Pressure Sensor (FTPS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

Measure the output voltage of the FTPS.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the rear seat. (Refer to Body - "Seat")

3.	Remove the fuel pump service cover (A).

4.	Disconnect the fuel tank pressure sensor connector (A).

5.	Remove the fuel tank pressure sensor after releasing the hooks vertically.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Insert the sensor in the installation hole and be careful not to damage when installation.

1.	Install in the reverse order of removal.

Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Injector Description and Operation

Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as i ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Transfer Fluid Repair procedures
Inspection • Transfer oil should be inspected and refilled every 60000 km (40000 mile) / 4 year. 1. Remove the under cover (A). 2. Remove the oil filler plug (A). 3. Check the oil level. Oil level must be up to fill the hole, if not, ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Fuel Gauge
This gauge indicates the approximate amount of fuel remaining in the fuel tank. ✽ NOTICE The fuel tank capacity is given in chapter 8. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On inclines or curves, the fu ...