Hyundai Tucson: Engine oil / Checking the engine oil level
1. Follow all of the oil manufacturer’s precautions.
2. Be sure the vehicle is on level ground in P (Park) with the parking brake set and the wheels blocked.
3. Turn the engine on and allow the engine to reach normal operating temperature.
4. Turn the engine off and wait about five minutes for the oil to return to the oil pan.
5. Pull the dipstick out, wipe it clean, and re-insert it fully.
6. Pull the dipstick out again and check the level. The level should be between F and L.
7. If it is near or at L, add enough oil to bring the level to F.
✽ NOTICE
To prevent damage to your engine:
- Do not overfill with engine oil. Add oil in small quantities and recheck level to ensure engine is not overfilled.
- Do not spill engine oil when adding or changing engine oil. Use a funnel to help prevent oil from being spilled on engine components. Wipe off spilled oil immediately
✽ NOTICE
Use only the specified engine oil
Engine oil
...
Checking the engine oil and filter
Have engine oil and filter changed by an authorized HYUNDAI dealer according
to the Maintenance Schedule at the beginning of this chapter.
WARNING
CALIFORNIA PROPOSITION 65 WARNING
Engine oil c ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :
20 ~ 25 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.2 lb-ft)
2.
Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and cl ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Output Speed Sensor Description and Operation
Description
The Output Speed Sensor is a vital unit that measures the
rate of rotation of the transmission's turbine shaft and output shaft,
and delivers the readings to the TCM.
The sensor provides critical input data that's used in
feedback control, damper clutch control, g ...