Hyundai Tucson: Evaporative Emission Control System / Fuel Tank Air Filter Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter Repair procedures

Replacement

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Lift the vehicle with a jack.

3.	Disconnect the canister close valve connector (A).

4.	Disconnect the ventilation hose (B) and vapor hose (C).

5.	Remove the fuel tank air filter and canister close valve assembly (A) after removing the installation nut (B).

6.	Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.

7.	Install a new fuel tank air filter in accordance with the reverse order.

Fuel Filler Cap Description and Operation

Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and t ...

Exhaust Emission Control System

...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ConditionOutput Voltage (V)Idle Approx. 1.21,500 rpm2.2 ~ 2.56,300 rpm Approx. 3.0 Removal 1. Turn the ignition switch OFF and dis ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Intake Actuator Description and Operation
Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit. 3. Pressing the intake selection switch will shift between recirculation and fresh air modes. ...