Hyundai Tucson: Evaporative Emission Control System / Fuel Filler Cap Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Filler Cap Description and Operation

Description

A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set.

1. Cover
2. Torsion spring
3. Retainer
4. Gasket seal

5. Spring
6. Plate seal
7. Vacuum valve
8. Spring

Canister Repair procedures

Removal 1. Remove the fuel tank. (Refer to "Fuel tank" in FL group.) 2. Disconnect the vapor tube quick-connector (A,B) and the ventilation hose (C). 3. Remove the canister in the direct ...

Fuel Tank Air Filter Repair procedures

Replacement 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle with a jack. 3. Disconnect the canister close valve connector (A). 4. Dis ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Knock Sensor (KS) Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pressure to the piez ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: ESC indicator (Electronic Stability Control)
The ESC indicator will illuminate when the ignition switch is turned ON, but should go off after approximately 3 seconds. When the ESC is on, it monitors the driving conditions and under normal driving conditions, the ESC indicator will remain off. When a slippery or low traction condition ...