Hyundai Tucson: Heater / Heater Core Repair procedures

Replacement
1.
Remove the crash pad.
(Refer to Heater - "Heater Unit")
2.
Loosen the mounting screw and then remove the heater core cover (A).

3.
Remove the heater core.
4.
Be careful that the inlet and outlet pipe are not bent during heater core removal, and pull out the heater core.
5.
Install in the reverse order of removal.
Heater Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coola ...

Evaporator Core Repair procedures
Replacement 1. Remove the crash pad. (Refer to Heater - "Heater Unit") 2. Loosen the heater unit lower case mount screw and then remove the heater unit lower case (A). 3. Remove the evap ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Brake Line Repair procedures
Removal 1. Disconnect the brake fiuid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder reservior with a syringe.     Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the ...

Hyundai Tucson (LM) 2010-2015 Service Manual: In car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow air with changing temperature to the in car sensor air inlet. Measure sensor resistance between 1 and 2 terminals. 1. Sensor Ground2. Incar Sensor Signal Specification Temperature [°C(°F)] Resistance between terminals 1and 2 (kx)-20(-4)290.21-10(1 ...

© 2010-2019 www.htmanual.net