Hyundai Tucson: What to do in an emergency / If the engine will not start

Hyundai Tucson (LM) 2010-2015 Owners Manual / What to do in an emergency / If the engine will not start

If the engine doesn't turn over or turns over slowly

Be sure the shift lever is in N (Neutral) or P (Park). The engine starts only when the shift lever is in N (Neutral) or P (Park).
Check the battery connections to be sure they are clean and tight.
Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is drained. Do not push or pull the vehicle to start it. This could cause damage to your vehicle. See instructions for "Jump Starting" provided in this chapter.

WARNING

Push or pull starting the vehicle may cause the catalytic converter to overload which can lead to damage to the emission control system.

If the engine turns over normally but doesn’t start

Check the fuel level and add fuel if necessary.

If the engine still does not start, call an authorized HYUNDAI dealer or seek other qualified assistance.

In case of an emergency while driving

If the engine stalls while driving Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. Turn on your hazard warning flasher. Try to start the ...

Jump starting

Jump starting can be dangerous if done incorrectly. Follow the jump starting procedure in this section to avoid serious injury or damage to your vehicle. If in doubt about how to properly jump sta ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Front seat warmers (if equipped)
While the engine is running, push either of the switches to warm the driver's seat or front passenger's seat. During mild weather or under conditions where the operation of the seat warmer is not needed, keep the switches in the OFF position. Each time you push the switch, the temperature ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable. When the ignition key is turned to the start position, current flows and energizes ...