Hyundai Tucson: Ignition switch / Key ignition switch

WARNING

NEVER turn the ignition switch to the LOCK or ACC position while the vehicle is in motion except in an emergency. This will result in the engine turning off and loss of power assist for the steering and brake systems. This may lead to loss of directional control and braking function, which could cause an accident.

Before leaving the driver’s seat, always make sure the shift lever is in position, apply the parking brake, and turn ignition switch to the LOCK position. Unexpected vehicle movement may occur if these precautions are not followed.

Ignition switch
WARNING To reduce the risk of SERIOUS INJURY or DEATH, take the following precautions: NEVER allow children or any person who is unfamiliar with the vehicle to touch the ignition switch or rel ...

Key ignition switch positions
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Accelerator Position Sensor (APS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. Specification: Refer to “Specification” Removal 1. Turn the ignition switch OFF and disconnect the negative ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Engine Control Module (ECM) Repair procedures
Removal     When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" procedure with GDS. (Refer to Body Electrical System - "Immobilizer system") 2) After finis ...

© 2010-2020 www.htmanual.net