Hyundai Tucson: Starting System / Starter Description and Operation
Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Electrical System / Starting System / Starter Description and Operation
| Description |
The starting system includes the battery, starter, solenoid
switch, ignition switch, inhibitor switch (A/T), clutch pedal switch
(M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated,
and the clutch pinion engages the ring gear.The contacts close and the
starter motor cranks.
In order to prevent damage caused by excessive rotation of
the starter armature when the engine starts, the clutch pinion gear
overruns.
| 1. Switch assembly 2. Yoke assembly 3. Armature 4. Over runing clutch |
Troubleshooting
Troubleshooting
•
The battery must be in good condition and fully charged for this troubleshooting.
...
Starter Specifications
Specification
ItemSpecificationRated voltage12 V, 1.2 kWThe number of pinion teeth13Performance[No-load, 11 V]AmpereMax. 70 ASpeedMin. 2,400 rpm
...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Knock Sensor (KS) Specifications
Specification
ItemSpecificationCapacitance (pF)850 ~ 1,150
...
Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Seat Belt Repair procedures
Replacement
Secondary Seat Belt Relacement
•
When installing the belt, make sure not to damaged the retractor.
1.
Remove the rear seat.
(Refer to Seat & Power Seat - "Rear Seat")
2.
Remove the rear door scuff trim.
(Refer to Interior - "Interior Trim")
...
© 2010-2026 www.htmanual.net
