Hyundai Tucson: Engine Electrical System
- General Information
- Ignition System
- Description and Operation
- Repair procedures
- Ignition Coil Description and Operation
- Ignition Coil Specifications
- Ignition Coil Schematic Diagrams
- Ignition Coil Repair procedures
- Spark Plug Description and Operation
- Spark Plug Specifications
- Spark Plug Repair procedures
- Charging System
- Description and Operation
- Repair procedures
- Alternator Description and Operation
- Alternator Specifications
- Alternator Components and Components Location
- Alternator Schematic Diagrams
- Alternator Repair procedures
- Battery Description and Operation
- Battery Specifications
- Battery Components and Components Location
- Battery Repair procedures
- Battery Troubleshooting
- Battery Sensor Description and Operation
- Battery Sensor Repair procedures
- Starting System
- Description and Operation
- Troubleshooting
- Starter Description and Operation
- Starter Specifications
- Starter Components and Components Location
- Starter Schematic Diagrams
- Starter Repair procedures
- Starter Relay Repair procedures
- Cruise Control System
Muffler Repair procedures
Removal and Installation
Front Muffler
1.
Disconnect the front oxygen sensor connector (A) and then remove it from the bracket.
2.
Remove the front muffler (B).
Tightening torque :
39.2 ~ ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Differential Carrier Components and Components Location
Components Location
1. Rear Differential Carrier2. Coupling Assembly
Components
1. Pinion lock nut2. Pinion oil seal3. Pinion front bearing4. Differential case bracket5. Differential case6. Pinion bearing spacer7. Drive gear8. Ring gear9. Gear carrier assembly10. Side bearing outer race11 ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Removal
1.
Remove the liftgate trim in the trunk after removing the screws and clips.
(Refer to the BD group - "Liftgate")
2.
Remove the liftgate garnish (A) after disconnecting the connector and removing the nuts.
3.
Remove the back view camera (A) after loosening the screws (2EA).
...
