Hyundai Tucson: Ignition System / Ignition Coil Description and Operation

Description
An ignition coil is an induction coil in an engine's ignition system which transforms the battery's low voltage to the high voltage needed to create an electric spark in the spark plugs to ignite the fuel. Coils have an internal resistor while others rely on a resistor wire or an external resistor to limit the current flowing into the coil from the battery 12 V supply.
Repair procedures
On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.     • If a DTC is present, perform troubleshooting in accordance with the ...

Ignition Coil Specifications
Specification ItemSpecification Primary Coil Resistance (x)0.75 ± 15% [20°C (68°F)]Secondary Coil Resistance (kx)5.9 ± 15% [20°C (68°F)] ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resistance is within the specification. Removal     Replacing an on/off soleno ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Injector Troubleshooting
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from the low side of ...

© 2010-2019 www.htmanual.net