Hyundai Tucson: Ignition System / Ignition Coil Repair procedures

Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connectors (A).

   
•
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

4.
Remove the ignition coil (A).

Installation
1.
Install in the reverse order of removal.

Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)

Inspection
1.
Measure the primary coil resistance between terminals (+) and (-).


Standard value: 0.75x ± 15%

Ignition Coil Schematic Diagrams
Circuit Diagram [M/T] [A/T] ...

Spark Plug Description and Operation
Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture there ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or the other ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Side Impact Sensor (SIS) Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH). Side Pressure Sensor is also called P-SIS because that detects pressure due to c ...

© 2010-2026 www.htmanual.net