Hyundai Tucson: Propeller Shaft Assembly / Propeller Shaft Repair procedures

Removal
1.
After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A).

Tightening torque:
49.0 ~ 68.6 N.m (5.0 ~ 7.0 kgf.m, 36.1 ~ 50.6 lb-ft)

2.
Remove the center bearing bracket (A) mounting bolts (B-2ea).

Tightening torque:
49.0 ~ 68.6 N.m (5.0 ~ 7.0 kgf.m, 36.1 ~ 50.6 lb-ft)

3.
After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A).

Tightening torque:
49.0 ~ 68.6 N.m (5.0 ~ 7.0 kgf.m, 36.1 ~ 50.6 lb-ft)

   
Do not reuse bolts.

4.
Install in the reverse order of removal.
   
•
When assembling propeller shaft, locate marks on flange yoke and T/M transfer flange to be nearly the same loacation.
Propeller Shaft Components and Components Location
Components 1. Front propeller shaft2. Center bearing bracket3. Rear propeller shaft ...

Differential Carrier Assembly
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: TPMS Receiver Schematic Diagrams
Schematic diagram Connector Information PinDescription1Battery2CAN_High3GND4-5-6-7IGN8CAN_Low9-10-11-12- ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Body Control Module (BCM) Description and Operation
Body Control Module (BCM) Funtionsscription FunctionDescriptionFRONT WASHER LINKED WIPERx With IGN2 ON, turning ON the WasherSW turns ON the Wiper and turning OFF the WasherSW keeps Wiper output for 2.5~3.8 seconds then turns OFF.INT WIPERx With IGN2 ON, turning ON the FRWiperIntSW operates ...

© 2010-2026 www.htmanual.net