Hyundai Tucson: Engine Control System / Purge Control Solenoid Valve (PCSV) Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Description and Operation

Description

Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in the canister is transferred to the intake manifold.

Injector Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within t ...

Purge Control Solenoid Valve (PCSV) Specifications

Specification ItemSpecificationCoil Resistance (x)22.0 ~ 26.0 [20°C(68°F)] ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Engine Control Module (ECM) Repair procedures
Removal When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" procedure with GDS. (Refer to Body Electrical System - "Immobilizer system") 2) After finis ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Driveshaft Components and Components Location
Components 1. Tone wheel2. BJ joint3. BJ boot4. BJ boot big part band5. BJ boot small part band6. Shaft7. TJ boot small part band8. TJ boot big part band9. TJ boot10. Snap ring11. Circlip12. TJ assembly ...