| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Loose the screws (2EA) holding the rear combination lamp then
disconnect the connector (A) then remove the outside rear combination
lamp (B).
|
| 3. |
Turn the socket counterclockwise to remove the tail/stop lamp bulb (A) and turn signal lamp bulb (B).
|
| 4. |
Loosen the nuts (A) after removing the liftgate lamp cover.
|
| 5. |
Remove the liftgate lamp (B) after disconnecting the connector (A).
|
| 6. |
Turn the socket counterclockwise to remove the back up lamp bulb (A) and tail lamp bulb (B).
|
| 7. |
If the bulbs should be only replaced without removing lamp
assembly, replace the back up lamp bulb (A) and tail lamp bulb (B) after
removing the liftgate lamp cover inside trunk.
|
| Installation |
| 1. |
Install the liftgate combination lamp assembly after assembling the bulb. |
| 2. |
Install the lamp cover to the liftgate after connecting the lamp connector. |
| 3. |
Install the rear combination lamp assembly after assembling the bulbs and connecting the lamp connector. |
Luggage Room Lamp Repair procedures
TroubleshootingHyundai Tucson (LM) 2010-2015 Owners Manual: Additional safety precautions
Passengers should not move out of or change seats while the vehicle is moving.
A passenger who is not wearing a seat belt during a crash or emergency stop can
be thrown against the inside of the vehicle, against other occupants, or be ejected
from the vehicle.
Do not use any accessories on se ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Inhibitor Switch Troubleshooting
Fault Diagnosis
Fault Diagnosis for Symptom
Major Symptom Expected Cause Items to Check and Measures Shift lever not operating Gear not marked on cluster Shock occurs while shifting lever Warning lamp ON Engine OFF while vehicle is parked Inhibitor switch circuit abnor ...