Hyundai Tucson: Lighting System / Luggage Room Lamp Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage room lamp (B) when prying the hole (A) with a flat-up screwdriver

3.
Remove the luggage room lamp bulb in case of necessity
Installation
1.
Replace the lamp bulb.
2.
Install the luggage room lamp assembly after connecting the lamp connector.
High Mounted stop lamp Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the liftgate trim. (Refer to the BD group - "Liftgate") 3. Remove the spoiler. (Refer to the ...

Rear combination lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the screws (2EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combinatio ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ConditionOutput Voltage (V)Idle Approx. 1.21,500 rpm2.2 ~ 2.56,300 rpm Approx. 3.0 Removal 1. Turn the ignition switch OFF and dis ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module). The engine operating conditions (speed, load, wa ...

© 2010-2024 www.htmanual.net