Hyundai Tucson: Manual Transaxle System / Repair procedures

Inspection
Manual Transaxle Oil Inspection
1.
Park the vehicle on a level ground and stop the engine.
2.
Retighten the oil filler plug (A) with a new washer.

3.
Check level with finger.
   
Oil level must be up to fill the hole, if not, add oil until it runs over.

4.
Install filler plug.

Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)

Manual Transaxle Oil Replacement
1.
Park the vehicle on a level ground and stop the engine.
2.
Drain the manual transaxle oil after loosening the drain plug (A).

3.
Install the drain plug with new gasket.

Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)

4.
Add new oil through the filler plug hole and, fill it just below the plug opening.

Standard oil: SAE 75W/85, API GL-4
Oil capacity:
1.9 ~ 2.0 L (0.50 ~ 0.53 U.S.gal., 2.01 ~ 2.11 U.S. qt., 1.67 ~ 1.76 lmp qt.)

Manual Transaxle System
...

Manual Transaxle Components and Components Location
Components 1. Clutch housing2. Back-up lamp switch3. Control shaft complete 4. Manual transaxle case ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Instrument Cluster Components and Components Location
Components (1) Components (2) ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Heater Unit Components and Components Location
Component Location Components 1. Heater Case (LH)2. Heater Core Cover3. Mode Actuator4. Shower Duct (LH)5. Temp Actuator (Drive)6. Evaporator Sensor7. Def Door Lever8. Vent Door Lever9. Foot Sub Lever10. Def Door11. Vent Door (LH)12. Foot Door13. Mix Door (LH)(Auto Type)14. Heater Core15. Duct ...

В© 2010-2026 www.htmanual.net