Hyundai Tucson: Lighting System / Room Lamp Repair procedures

Inspection
1.
Remove the room lamp assembly connector (A) then check for continuity between terminals.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver.

   
Push the lens as shown arrow direction.
Take care not to damage the part (B).
3.
Loosen the fixing screw (2EA).

4.
Remove the room lamp assembly (A) after disconnecting the connector (B).

Installation
1.
Install the room lamp assembly after connecting the lamp connector.
2.
Install the lamp lens after assembling the bulb.
Head Lamps Repair procedures
Removal     Head lamps become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off.     The headlamp b ...

Overhead Console Lamp Repair procedures
Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.Removal 1. Disconnect th ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Tire terminology and definitions
Air Pressure The amount of air inside the tire pressing outward on the tire. Air pressure is expressed in pounds per square inch (psi) or kilopascal (kPa). Accessory Weight This means the combined weight of optional accessories. Some examples of optional accessories are automatic transmission ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: For safe AWD operation
Before driving Make sure all passengers are wearing seat belts. Sit upright and closer to the steering wheel than usual. Adjust the steering wheel to a position comfortable for you to drive. Driving on snow-covered or icy roads Start off slowly by applying the accelerator pedal gentl ...

В© 2010-2026 www.htmanual.net