Hyundai Tucson: Lighting System / Overhead Console Lamp Repair procedures

Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp assembly.
(Refer to the BD group - "Roof trim")
3.
Remove the overhead console bulb (B) after disconnecting the panoramaroof switch connector and lamp connector (A).

4.
When replacing the bulb only, release the lens (C) cover from the roof without removing the overhead console lamp assembly.
Installation
1.
Install the bulbs and connect the connectors.
2.
Install the overhead console lamp assembly.
Room Lamp Repair procedures
Inspection 1. Remove the room lamp assembly connector (A) then check for continuity between terminals. Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) ...

Hazard Lamp Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the hazard lamp switch assembly. (Refer to the BE group - "Audio head unit") 3. Disconnect the hazard lamp switch conne ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Intake Manifold Repair procedures
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal. Tightening torque: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft) 3. Disconnect the wiring connectors and harness clamps, and then remove the wiring and protectors from the intake m ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil Pump Components and Components Location
Components [Without Oil Level Sensor] 1. Timing chain cover2. Outer roter3. Inner roter4. Oil pump cover5. Relief plunger6. Relief spring7. Relief plug8. O-ring (suction side)9. O-ring (discharge side)10. Oil screen gasket11. Oil screen12. Oil pan13. Oil filter14. OPS (Oil pressure switch) ...

В© 2010-2026 www.htmanual.net