Hyundai Tucson: Lighting System / Hazard Lamp Switch Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the hazard lamp switch assembly. (Refer to the BE group - "Audio head unit")

3.	Disconnect the hazard lamp switch connector (A).

4.	If the hazard lamp switch is not as specified, replace it carefully and take care not to damage the hook (A).

Installation

1.	Connect the hazard switch connector.

2.	Install the hazard switch assembly.

Inspection

1.	Operate the switch and check for continuity between terminals with an ohmmeter.

Overhead Console Lamp Repair procedures

Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.Removal 1. Disconnect th ...

Rheostat Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the crash pad side switch assembly (A) as ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Timing Chain Repair procedures
Removal Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. Mark all wiring and ho ...

Hyundai Tucson (LM) 2010-2015 Service Manual: In car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow air with changing temperature to the in car sensor air inlet. Measure sensor resistance between 1 and 2 terminals. 1. Sensor Ground2. Incar Sensor Signal Specification Temperature [°C(°F)] Resistance between terminals 1and 2 (kx)-20(-4)290.21-10(1 ...