Hyundai Tucson: Lighting System / Rheostat Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Lighting System / Rheostat Repair procedures

Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to the BD group - "Crash pad")

Remove the crash pad side switch assembly (A) as shown below picture.

Put on gloves to protect your hands.

Remove the rheostat switch (A) after disconnecting the connectors.

Take care not to damage the hook when removing the rheostat switch.

5.	Operate the switch and check for continuity between terminals with an ohmmeter.

Hazard Lamp Switch Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the hazard lamp switch assembly. (Refer to the BE group - "Audio head unit") 3. Disconnect the hazard lamp switch conne ...

Front Fog Lamps Repair procedures

Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Pressure Sensor Description and Operation
Description The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque value varies according to a pressure status. ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Timing Chain Components and Components Location
Components 1. Intake camshaft2. Exhaust camshaft3. Intake CVVT assembly4. Exhaust CVVT assembly5. Timing chain6. Timing chain tensioner arm7. Timing chain tensioner8. Timing chain guide9. Timing chain cover10. Service plug bolt & gasket11. Front oil seal12. Crankshaft damper pulley ...