| Inspection |
| 1. |
With the fog lamp switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the multifunction switch.
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front bumper.
(Refer to the BD group - "Front bumper") |
| 3. |
Remove the front fog lamp (A) by turning in the counterclockwise direction after disconnecting the connector.
|
| 4. |
Remove the front fog lamp (A) after loosening the screws.
|
| Installation |
| 1. |
Install the front fog lamp bulb. |
| 2. |
Connect the front fog lamp connector. |
| 3. |
Install the front bumper. |
Rheostat Repair procedures
License Lamps Repair proceduresHyundai Tucson (LM) 2010-2015 Service Manual: Specifications
Specifications
ItemSpecificationPower sourceDC 14.4V (-) groundFrequency range / Channel spaceFM : 87.5 ~ 108.0 MHz / 100 KHzAM : 531 ~ 1602 KHz / 9 KHzTuning typePLL SYNTHESIZED TUNINGImpedance2 ohm x 4Antenna80 pF 75 ohmDark currentMAX 2mA (Head unit only)S/NFM : MIN 50 dBAM : MIN 40 dB
GP ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
OBD-II review
1. Overview
The California Air Resources Board (CARB) began regulation of
On Board Diagnostics (OBD) for vehicles sold in California beginning
with the 1988 model year. The first phase, OBD-I, required monitoring of
the fuel metering system, Exhaust Gas Recirculation (EGR) sy ...