Hyundai Tucson: Lighting System / License Lamps Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp lens (B) by pressing the clip (A).

3.
Turn the license bulb socket (A) counterclockwise to remove the bulb (B) from lens (C).

Installation
1.
Install the bulb.
2.
Install the license lamp lens.
Front Fog Lamps Repair procedures
Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

High Mounted stop lamp Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the liftgate trim. (Refer to the BD group - "Liftgate") 3. Remove the spoiler. (Refer to the ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: TJ Joint Components and Components Location
Components [LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft6. TJ boot band7. TJ boot8. Spider assembly9. Retainer ring10. TJ housing11. Housing circlip [RH] 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ b ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Fuel Pressure Control Valve Repair procedures
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fuel pressure regulator valve terminals 1 and 2. 4. Check that the resistance is within the specifica ...

В© 2010-2026 www.htmanual.net