| Inspection |
| 1. |
After disconnecting the vapor hose from the PCV valve, remove the PCV valve. |
| 2. |
Reconnect the PCV valve to the vapor hose. |
| 3. |
Run the engine at idle, then put a finger over the open end
of the PCV valve and make sure that intake manifold vacuum can be felt.
|
| 4. |
If the vacuum is not felt inspect PCV operation, if operating correctly clean or replace the vapor hose. |
Schematic Diagrams
Positive Crankcase Ventilation (PCV) Valve Description and OperationHyundai Tucson (LM) 2010-2015 Service Manual: General Information
Identification Number Locations
Identification Number Description
Vehicle Identification Number
1.
World Manufacturer Identifier (WMI)
A.
KMF : Commercial vehicle (Van)
B.
KMH : Passenger vehicle or MPV(Multipurpose Passenger Vehicle)/SUV(Sports Utility Vehicle)/RV(Recreational Vehicle)
...
Hyundai Tucson (LM) 2010-2015 Service Manual: Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switc ...