Hyundai Tucson: Rear Suspension System / Trailing Arm Repair procedures
Hyundai Tucson (LM) 2010-2015 Service Manual / Suspension System / Rear Suspension System / Trailing Arm Repair procedures
| Replacement |
| 1. |
Remove the rear wheel & tire.
|
| 2. |
Loosen the nuts & bolts and then remove the trailing arm (A) with the rear axle.
[2WD]
[4WD]
|
| 3. |
Loosen the mounting bolt and then remove the trailing arm (A) with the frame.
|
| 4. |
Installation is the reverse of removal. |
Rear Assist Arm Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolts whe ...
Rear Cross Member Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Be careful not to damage to the hub bolts ...
Other information:
Hyundai Tucson (LM) 2010-2015 Owners Manual: Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 (or 3) fuse panels, one located in the driver’s side panel
bolster, the other in the engine compartment near the battery.
If any of your vehicle’s lights, accessories, or controls do ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Input Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor conn ...
© 2010-2026 www.htmanual.net
