Hyundai Tucson: Suspension System / Rear Suspension System
- Components and Components Location
- Rear Shock Absorber Components and Components Location
- Rear Shock Absorber Repair procedures
- Rear Upper Arm Repair procedures
- Rear Lower Arm Repair procedures
- Rear Stabilizer Bar Repair procedures
- Rear Assist Arm Repair procedures
- Trailing Arm Repair procedures
- Rear Cross Member Repair procedures
- Rear Coil Spring Repair procedures
Front Cross Member Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9 N.m(9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Be careful not to damage to the hub bolts w ...
Components and Components Location
Components
[4WD]
1. Sub frame2. Shock absorber3. Coil spring4. Upper arm5. Trailing arm6. Drive shaft rear axle7. Differential carrier
[2WD]
1. Sub frame2. Shock absorber3. Coil sprin ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) af ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Ultrasonic Sensor Repair procedures
Removal
1.
Remove the rear bumper.
(Refer to the BD group - "Rear bumper")
2.
Disconnect the sensor connector (A) inside the rear bumper.
3.
Pull out the sensor (A) by opening the sensor holder (B) out.
Installation
1.
Connect the connector, and then reassemble the sensor.
2.
I ...
