Hyundai Tucson: Automatic Transaxle Control System / Repair procedures
When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement |
| 1. |
TCM learning condition
| A. |
ATF temperature: 60 ~ 115°C (140 ~ 239°F) |
|
| 2. |
TCM learning procedure
| A. |
Stop learning
Repeat the below shift pattern four times or more with stepping on the brake. 
|
| 1. |
Drive the vehicle through all gears at D range. Drive from
stop to 1st to 2nd to 3rd to 4th to 5th to 6th with keeping fixed
throttle open. |
| 2. |
Down shift from 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st. |
| 3. |
Repeat the above driving pattern four times or more.
Up-shift throttle open : 15 ~ 30% |
|
Description
Automatic Transaxle System relies on various measurement data
to determine the current control status and extrapolate the necessary
compensation values. These values are used to con ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
General Inspection
After or before servicing the EPS system, perform the
troubleshooting and test procedure as follows. Compare the system
condition with normal condition in the table below and if abnormal
symptom is detected, perform necessary remedy and inspection.
Test conditionNormal ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Description and Operation
Description
Automatic Transaxle System relies on various measurement data
to determine the current control status and extrapolate the necessary
compensation values. These values are used to control the actuators and
achieve the desired control output.
If a problem with ...
Description and Operation
Schematic Diagrams