Hyundai Tucson: General Information / Repair procedures
| Component Replacement After Deployment |
Before doing any SRS repairs, use the GDS Pro to check for
DTCs. Refer to the Diagnostic Trouble Code list for repairing of the
related DTCs. |
| - |
SRSCM |
| - |
Deployed airbag(s) |
| - |
Seat belt pretensioner(s) |
| - |
Front impact sensors |
| - |
SRS wiring harnesses |
| - |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
| - |
SRSCM |
| - |
Deployed airbag(s) |
| - |
Side impact sensor(s) for the deployed side(s) |
| - |
SRS wiring harnesses
|
| - |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Description and Operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition On
As soon as the operating voltage is applied to the SRSCM
ignition input, the SRSCM activates the warning lamp for a LED lamp
c ...
Components and Components Location
Components
1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring4. Seat Belt Pretensioner (BPT)5. Pressure Side Impact Sensor (P-SIS)6. Side Impact Sensor (SIS)7. Side Airbag (SAB)8. Passenger A ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Propeller Shaft Repair procedures
Removal
1.
After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6 N.m (5.0 ~ 7.0 kgf.m, 36.1 ~ 50.6 lb-ft)
2.
Remove the center bearing bracket (A) mounting bolts (B-2ea).
Tightening to ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Back-up Lamp Switch Repair procedures
Inspection
1.
Disconnect the back up lamp switch connector (A).
2.
Check the continuity between no. 1 and 2 terminals of backup
lamp switch. When the shift lever is in reverse, there should be
continuity.
3.
If necessary, repair or replace the backup lamp switch.
Replacement
1. ...
