Adjusting the seats so that you are sitting in a safe, comfortable position plays an important role in driver and passenger safety together with the seat belts and air bags in an accident.
WARNING
Do not use a cushion that reduces friction between the seat and the passenger. The passenger's hips may slide under the lap portion of the seat belt during an accident or a sudden stop. Serious or fatal internal injuries could result because the seat belt cannot operate normally.
Air bags
You can take steps to reduce the risk of being injured by an inflating air bag. Sitting too close to an air bag greatly increases the risk of injury in the event the air bag inflates.
The National Highway Traffic Safety Administration (NHTSA) recommends that drivers allow at least 10 inches (25 cm) between the center of the steering wheel and their chest.
WARNING
To reduce the risk of serious injury or death from an inflating air bag, take the following precautions:
Seat belts
Always fasten your seat belt before starting any trip.
At all times, passengers should sit upright and be properly restrained.
Infants and small children must be restrained in appropriate child restraint systems.Children who have outgrown a booster seat and adults must be restrained using the seat belts.
WARNING
Take the following precautions when adjusting your seat belt:
Seats
Front seatsHyundai Tucson (LM) 2010-2015 Service Manual: Ambient Sensor Repair procedures
Inspection
1.
Ignition "OFF"
2.
Disconnect ambient temperature sensor.
3.
Check the resistance of ambient temperature sensor between
terminals 1 and 2 whether it is changed by changing of the ambient
temperature.
1. Sensor Ground2. Ambient Sensor Signal
Specification
Ambient t ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Water pump Repair procedures
Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster.
2.
Remove the drive belt.
(Refer to Timing system in this group)
3.
Remove the water pump pulley (A).
Tightening torque:
9.8 ~ 11.8 N.m ( ...