Hyundai Tucson: Seat Electrical / Seat Heater Repair procedures

Removal
1.
Remove the seat back cover and cushion cover.
(Refer to the BD group - "Front seat")
2.
Remove the driver / assist seat back heater (A) and cushion heater (B).

Installation
1.
Install the driver / assist seat back and cushion heater.
Inspection
First Seat Heater
1.
Check for continuity and measure the resistance between terminals as below.

No.
Description
No.
Description
1
High
3
GND
2
Low
4
Indicator


Standard value
Cushion : 1.32x ± 10% (leather), 1.76x ± 10% (fabric)
Back : 1.85x ± 10%
Set : 3.17x ± 10% (leather), 3.61x ± 10% (fabric)

2.
Operate the seat warmer after connecting the 4P connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value
High : 107.6 ± 3.6°F (42 ± 2°C) (Cushion),
125.6 ± 3.6°F (52 ± 2°C) (Back)
Low : 104 ± 3.6°F (40 ± 2°C) (Cushion),
114.8 ± 3.6°F (46 ± 2°C) (Back)

Seat Heater Components and Components Location
Component Location ...

Fuses And Relays
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Fuel Pressure Control Valve Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Yaw-rate and G Sensor Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the floor console. 3. Disconnect the yaw rate & lateral & Longitudinal G sensor connector (A). 4. Remove the mounting bolts (B). Tightening torque: 7.9 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m ...

© 2010-2025 www.htmanual.net