Hyundai Tucson: General Information / Special Service Tools

Special Service Tools
Tools (Number and name)
Illustration
Use
09200-3N000
Engine support fixture
(Beam)

Removal and installation of the transaxle.
Use this beam (SST No. : 09200-38001/09200-3N000) with the supporter (SST No. : 09200-2S000).
09200-2S000
Engine support fixture
(Adapter)

Removal and installation of the transaxle.
Use this beam (SST No. : 09200-38001/09200-3N000) with the supporter (SST No. : 09200-2S000).
09453-3L241
Oil seal installer

Installation of oil seal in the transaxle case side and the transaxle housing side.
2WD : Transaxle case side (SST No.: 09453-3L241), Transaxle housing side (SST No.: 09453-3L241)
[Using with bar (SST No.: 09231-H1100)]
09453-2W100
Oil seal installer(4WD)

Installation of oil seal in the transaxle housing side.
4WD : Transaxle case side (SST No.: 09453-3L241), Transaxle housing side (SST No.: 09453-2W100)
[Using with bar (SST No.: 09231-H1100)]
09480-A3800
Inhibitor neutral fixed pin

Inhibitor neutral fixed.
09231-H1100
Bar

Installation of oil seal in the transaxle case side and the transaxle housing side.
[Using with oil seal installer (SST No.: 09453-3L241, 09453-2W100)

Specifications
Specifications ItemSpecificationsTransmission typeA6MF1Engine modelGasoline 2.0 GDITorque converter type3-element, 1-stage, 2-phase typeTorque converter sizeO236 mm (9.2913 in.)Oil pump systemPar ...

Troubleshooting
Fault Diagnosis Features a fail-safe mechanism that provides "limp-home" 4th gear hold to enable the vehicle to be driven to the owner's home or dealer shop. Fail-Safe: The TCM provides 4th ge ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resistance is within the specification. Removal     Replacing an on/off soleno ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Interior light bulb replacement
1. Using a flat-blade screwdriver, gently pry the lens from the interior lamp housing. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Align the lens tabs with the interior lamp housing notches and snap the lens into place. WARNING Use care not to ...

© 2010-2024 www.htmanual.net