| Specification |
| Item | Specification | |
| Compressor | Type | DVE16 |
| Oil type & Capacity | PAG OIL 120±10cc (4.2±0.35 OZ.) | |
| Pulley type | 6PK-TYPE | |
| Displacement | 160cc/rev | |
| Condenser | Heat rejection | 14,000±5% kcal/hr |
| A/C Pressure transducer | The method to measure the pressure | Voltage= 0.00878835 * Pressure (psig) + 0.5 |
| Expansion valve | Type | Block type |
| Refrigerant | Type | R-134a |
| Capacity [oz.(g)] | 550±25 (19.4±0.88) | |
| Item | Specification | |
| Fresh and recirculation | Operating method | Actuator |
| Blower | Type | Sirocco |
| Speed step | Auto + 8 speed (Automatic), 1~4speed (Manual) | |
| Speed control | Power mosfet (Auto) | |
| Air filter | Type | Particle filter |
| Item | Specification | |
| Heater | Type | Pin & Tube type |
| Heating capacity | 4,550 - 5% kcal/hr | |
| Mode operating method | Actuator | |
| Temperature operating method | Actuator | |
| Evaporator | Temperature control type | Evaporator temperature sensor |
| A/C ON/OFF [°C(°F)] | ON : 1.5 ± 0.3 (34.7 ± 32.5) OFF: -0.5 ± 0.3 (31.1 ± 32.5) | |
| Tightening Torque |
| Part tightened | N.m | Kgf.m | lb-ft |
| Condenser - Discharge hose | 4.9~5.9 | 0.5~0.6 | 3.6~4.3 |
| Condenser - Liquid tube | |||
| Compressor - Discharge hose | 4.9~5.9 | 0.5~0.6 | 3.6~4.3 |
| Compressor - Suction hose | |||
| Expansion valve - Evaporator | 11.8~14.7 | 1.2~1.5 | 8.7~10.9 |
TroubleshootingHyundai Tucson (LM) 2010-2015 Owners Manual: Temperature control
Use the temperature control knob to set the desired temperature in the cabin.
To increase the temperature, rotate the knob clockwise. To decrease the temperature,
rotate the knob counterclockwise.
To increase the temperature to the highest temperature setting, rotate the knob
clockwise con ...
Hyundai Tucson (LM) 2010-2015 Service Manual: 4WD ECU Repair procedures
Replacement
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool.
(Refer to 4WD Control System - "Adjustment")
2.
Disconnect the battery negative cable from the battery
3.
Disconnect the 4WD ECU connector (A).
4.
Loosen the nust (A) and then remo ...