Hyundai Tucson: General Information / Troubleshooting

Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.
Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts.
After correcting the malfunction, check the complete system to ensure that performance is satisfactory.
Symptom
Suspect Area
No blower operation
1.       Blower fuse
2.       Blower relay
3.       Blower motor
4.       Power mosfet
5.       Blower speed control switch
6.       Wire harness
No air temperature control
1.       Engine coolant capacity
2.       Heater control assembly
No compressor operation
1.       Refrigerant capacity
2.       A/C Fuse
3.       Magnetic clutch
4.       Compressor
5.       A/C pressure transducer
6.       A/C switch
7.       Evaporator temperature sensor
8.       Wire harness
No cool comes out
1.       Refrigerant capacity
2.       Refrigerant pressure
3.       Drive belt.
4.       Magnetic clutch.
5.       Compressor
6.       A/C pressure transducer
7.       Evaporator temperature sensor.
8.       A/C switch.
9.       Heater control assembly
10.    Wire harness
Insufficient cooling
1.       Refrigerant capacity
2.       Drive belt
3.       Magnetic clutch
4.       Compressor
5.       Condenser
6.       Expansion valve
7.       Evaporator
8.       Refrigerant lines
9.       A/C pressure transducer
10.    Heater control assembly
No engine idle-up when A/C switch ON
1.       Engine ECM
2.       Wire harness
No air inlet control
1.       Heater control assembly
No mode control
1.       Heater control assembly
2.       Mode actuator
No cooling fan operation
1.       Cooling fan fuse
2.       Fan motor
3.       Engine ECM
4.       Wire harness

Specifications
Specification Air Conditioner ItemSpecificationCompressorTypeDVE16Oil type & CapacityPAG OIL 120±10cc (4.2±0.35 OZ.)Pulley type6PK-TYPEDisplacement160cc/revCondenserHeat rejection14,000±5% ...

Special Service Tools
Special Service Tools Tool (Number and name)IllustrationUse09977-29000Disc & hub assembly bolt removerRemoval and installation of disc & hub assembly. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Variable Intake Solenoid (VIS) Valve Description and Operation
Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table). Engine condi ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Yaw-rate and G Sensor Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor. If yaw velocity reaches the specific velocity after it detects the vehicle'yawing, the ESP control ...

© 2010-2023 www.htmanual.net