Hyundai Tucson: Power windows / To reset the power windows
If the power windows do not operate normally, the automatic power window system must be reset as follows:
1. Place the ignition switch to the ON position.
2. Close the windows and continue pulling up on the power window switch for at least one second.
If the power windows do not operate properly after resetting, have the system checked by an authorized HYUNDAI dealer.
Auto up/down window
Pressing or pulling up the power window switch momentarily to the second detent
position (6) completely lowers or raises the window even when the switch is released.
To stop the window at the desi ...
Automatic reverse
If a window senses any obstacle while it is closing automatically, it will stop
and lower approximately 12 inch (30 cm) to allow the object to be cleared.
If the window detects the resistance w ...
Other information:
Hyundai Tucson (LM) 2010-2015 Service Manual: Engine Control Module (ECM) Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer system")
2) After finis ...
Hyundai Tucson (LM) 2010-2015 Service Manual: Driver Airbag (DAB) Module and Clock Spring Components and Components Location
Components
1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring
...
