Hyundai Tucson: Automatic Transaxle Control System / Transaxle Control Module (TCM) Description and Operation

Description
Transaxle Control Module (TCM) is the automatic transmission's brain. The module receives and processes signals from various sensors and implements a wide range of transmission controls to ensure optimal driving conditions for the driver.
TCM is programmed for optimal response to any on-road situation. In the event of a transmission failure or malfunction, TCM stores the fault information in memory so that the technician may reference the code and quickly repair the transmission.
Functions
•
Monitors the vehicle's operating conditions to determine the optimal gear setting.
•
Performs a gear change if the current gear setting differs from the identified optimal gear setting.
•
Determines the need for damper clutch (D/C) activation and engages the clutch accordingly.
•
Calculates the optimal line pressure level by constantly monitoring the torque level and adjusts the pressure accordingly.
•
Diagnoses the automatic transaxle for faults and failures.
Components and Components Location
Components Location [Vehicle Components] 1. Automatic transaxle2. Transaxle control module (TCM)3. Shift lever4. Data Link Connector (DLC) [Transaxle Components] 1. Input speed sensor2. Ou ...

Transaxle Control Module (TCM) Schematic Diagrams
1. TCM Connector and Terminal Function 2. TCM Terminal Function Connector [A] PinDescriptionPinDescription1-54-2-55-3-56-4-57-5-58Sport mode down switch6-59Oil temperature sensor (+)7-60-8-61-9-6 ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: 4WD ECU Schematic Diagrams
Circuit Diagram 4WD ECU Connector PinFunction1CAN communication line (Low)2CAN communication line (High)3-4Pressure sensor signal(+)5-6Lock mode switch7Oil pressure motor B8Oil pressure motor A9-10-11Pressure sensor(Input)12Input sensor signal(-)13Battery power 14Ground15IG power16-17-1 ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Rear Assist Arm Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bolts when removing the rear wheel & tire. 2. Remove the sprit pin and castle nut or bolt and then ...

© 2010-2026 www.htmanual.net