Hyundai Tucson: Hands Free System / Troubleshooting

Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetooth pairing (searching) mode
User’s phone is Bluetooth off mode
User’s phone set Bluetooth on
Making an attempt pairing others bluetooth system
Check Bluetooth device name and address (12 word) to attempt paring
Ex) 000B24FFF123
Pass key error
Input the passkey displayed on the audio screen into the phone.
5 phones have already been registered.
Delete paired phone list
Bluetooth system cannot communicate with the phone.
Refer to IOP sheet
 xIOP : Inter-operability
Not connection
User’s phone or Bluetooth device of Car dose not register
Bluetooth device to connect
Retry pairing 
Bluetooth system cannot communicate with the phone.
Waiting 1minute then Retry connection or phone power off/on.
Refer to IOP sheet
Not redial 
User phone system issue
Push the 2 times Send button
Not accept call
User phone system issue
Refer to IOP sheet
Not dialing
User’s phone playing other menu (internet, mp3, game, etc..)
Stop other menu then set normal mode
Bluetooth system cannot communicate with the phone
Refer to IOP sheet 

Hands Free Mic Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") 3. Remove the hands free mic (A) after loosening the connector an ...

Panoramaroof
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Knock Sensor (KS) Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pressure to the piez ...

Hyundai Tucson (LM) 2010-2015 Service Manual: CVVT (Continuously Variable Valve Timing) System Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which m ...

© 2010-2025 www.htmanual.net