Hyundai Tucson: Blower / Intake Actuator Description and Operation

Description
1.
The intake actuator is located at the blower unit.
2.
It regulates the intake door by signal from control unit.
3.
Pressing the intake selection switch will shift between recirculation and fresh air modes.
Intake Actuator Components and Components Location
Component Location ...

Intake Actuator Repair procedures
Inspection 1. Ignition "OFF" 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and groun ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: If you decide to pull a trailer?
Here are some important points if you decide to pull a trailer: Consider using a sway control.You can ask a trailer hitch dealer about sway control. Do not do any towing with your vehicle during its first 1,200 miles (2,000 km) in order to allow the engine to properly break in. Failure t ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Relay Box (Engine Compartment) Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Pull out the relay from the engine compartment relay box. Power Relay (Type A) Check for continuity between the terminals. A : Blower relay B : Horn relay C : Cooling fan relay (Low) D : Start relay E : Burglar horn rela ...

В© 2010-2026 www.htmanual.net