Hyundai Tucson: Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

Remove the steering column upper and lower shrouds (A) after removing 3 screws.

Take care not to damage and scratch the shrouds and its related parts.

Take care not to damage the hook when removing the upper and lower shrouds.

3.	Disconnect the light switch connector (A) and the wiper switch connector (B). [LHD] [RHD] [LHD] [RHD]

Remove the wiper switch (A) by pushing the lock pin (B).

When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

Installation

1.	Install the multifunction switch.

2.	Install the clock spring and steering wheel.

3.	Install the steering column upper and lower shrouds.

Inspection

Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch.

[LHD]

[RHD]

Wiper Switch

Washer Switch

Rear Wiper Switch

Rear Washer Switch

Components and Components Location

Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5. Washer motor (Front)6. Washer reservoir7. Wash ...

Front Wiper Motor Components and Components Location

Component Location 1. Cap2. Nut3. Wiper arm & blade4. Retainer5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly8. Wiper motor connector ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Child restraint system
WARNING Always properly restrain children in the rear seats of the vehicle. Children of all ages are safer when restrained in the rear seat. A child riding in the front passenger seat can be forcefully struck by an inflating air bag resulting in SERIOUS INJURY or DEATH. Children under age 13 ...

Hyundai Tucson (LM) 2010-2015 Service Manual: A/C Pressure Transducer Repair procedures
Inspection 1. Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals. 2. Inspect the voltage value whether it is sufficient to be regular value or not. Voltage = 0.00878835 * Pressure + 0.5 [PSIA] 3. If the measured voltage value is no ...