Hyundai Tucson: Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Description and Operation

Description
26 brake control solenoid valve(26/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake.

Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

26 Brake Control Solenoid Valve(26/B_VFS) Specifications
Specifications Direct control VFS[26/B] x Control type : Normal low type Control Pressure kpa (kgf/cmx, psi) 9.81 ~ 500.14(0.1 ~ 5.1, 1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal resis ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: Pairing through [PHONE] Setup
Press the key Select [Phone] Select [Pair Phone] Select TUNE knob 1. The following steps are the same as those described in the section "When No Devices have been Paired" on the previous page. ✽ NOTICE Bluetooth® Wireless Technology features supported within the vehicle are ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt.   ...

© 2010-2020 www.htmanual.net