Hyundai Tucson: Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

Removal

1.	Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air cleaner")

2.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

3.	Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.

Drain plug tightening torque :

38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

Replace the gasket before reinstalling the drain plug.

5.	Disconnect the air breather hose (A) from the valve body cover after disconnecting the clamp (B).

Remove the valve body cover (A).

Tightening torque :

(B) 13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

7.	Remove the bolts.

Disconnect the solenoid valve connector (B) and the oil temperature sensor (A) from the valve body.

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Remove the solenoid valve support bracket (B) and the valve body mounting bolt (A-1ea).

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

10.	Remove the torque converter control solenoid valve (A).

Installation

Install in the reverse order of removal.

•	Replace the valve body gasket (A) before reinstalling the valve body cover.

•	Adding automatic transaxle fluid. (Refer to Hydraulic system - "Fluid" )

•	Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup. (Refer to "Automatic transaxle control system - "Repair procedures")

Torque Converter Control Solenoid Valve (T/CON_VFS) Schematic Diagrams

Circuit Diagram ...

26 Brake Control Solenoid Valve(26/B_VFS) Description and Operation

Description 26 brake control solenoid valve(26/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake. ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resistance is within the specification. Removal Replacing an on/off soleno ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: To set cruise control speed
1.Push the cruise ON/OFF button on the steering wheel to turn the system on. The CRUISE indicator will illuminate. 2.Accelerate to the desired speed, which must be more than 25 mph (40 km/h). 3.Push the lever (1) down (to SET-) , and release it. The SET indicator light will illuminate. ...