Hyundai Tucson: Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the VIS valve connector.

Measure resistance between VIS valve terminals 1 and 2.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the variable intake solenoid valve connector (A).

3.	Disconnect the vacuum hoses (B) from the valve.

4.	Remove the installation nut, and then remove the valve from the surge tank.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Use care to keep foreign material out of the valve.

1.	Install in the reverse order of removal.

Variable Intake Solenoid (VIS) Valve Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Fuel Pressure Control Valve Description and Operation

Description Fuel Pressure Control Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on vario ...

Other information:

Hyundai Tucson (LM) 2010-2015 Owners Manual: ESC operation
ESC ON condition When the ignition switch is in the ON position, the ESC and the ESC OFF indicator lights illuminate for approximately three seconds and goes off, then the ESC is turned on. If this light stays on, your vehicle may have a malfunction with the ESC system. Have your vehicle che ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Brake Pedal Components and Components Location
Components 1. Cowl bracket2. Brake pedal member assembly3. Stop lamp switch4. Return spring5. Brake pedal stopper6. Clevis pin7. Snap pin8. Brake pedal ...