Hyundai Tucson: Rear Parking Assist System / Buzzer Repair procedures

Inspection
Test the buzzer by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The buzzer should make a sound. If the buzzer fails to make a sound, replace it.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
Remove the buzzer (A) after loosening the bolt and disconnecting the 2P connector.
[LHD]

[RHD]

Installation
1.
Connect the connector, and then install the buzzer.
2.
Install the crash pad lower panel.
Ultrasonic Sensor Repair procedures
Removal 1. Remove the rear bumper. (Refer to the BD group - "Rear bumper") 2. Disconnect the sensor connector (A) inside the rear bumper. 3. Pull out the sensor (A) by opening the sensor ...

Button Engine Start System
...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Components and Components Location
Components Location 1. Fuel tank2. Fuel pump3. Fuel filter4. Fuel pressure regulator5. Canister6. Fuel tank air filter7. Fuel tank band8. Fuel tank pressure sensor (FTPS) 9. Canister close valve (CCV) 10. Fuel level sender (FLS)11. Fuel filler hose12. Ventilation tube13. Vapor tube14. Fuel pump ...

Hyundai Tucson (LM) 2010-2015 Service Manual: SRS Control Module (SRSCM) Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Disconnect the DAB, PAB, SAB, CAB and BPT connectors. 4. Remove the floor console. (Refer to the Body group - console) 5. Pu ...

В© 2010-2026 www.htmanual.net