Hyundai Tucson: Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Hyundai Tucson (LM) 2010-2015 Service Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Inspection

Check the signal waveform of the CMPS and CKPS using the GDS.

Specification: Refer to “Wave Form”

Removal

•	DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

[Bank 1 / Intake]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the camshaft position sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor.

[Bank 1 / Exhaust]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the camshaft position sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

•	Be careful not to damage the sensor housing and the connector.

•	Be careful not to damage the O-ring.

Install in the reverse order of removal.

Camshaft position sensor installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Camshaft Position Sensor (CMPS) Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

Knock Sensor (KS) Description and Operation

Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Exhaust Manifold Repair procedures
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal. Tightening torque: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft) 3. Disconnect the front oxygen sensor connector (A) and then remove it from the bracket. 4. Remove the front muf ...

Hyundai Tucson (LM) 2010-2015 Owners Manual: Malfunction indicator (MIL) (check engine light)
This indicator light is part of the Engine Control System which monitors various emission control system components. If this light illuminates while driving, it indicates that a potential malfunction has been detected somewhere in the emission control system. This light will also illuminate ...