Hyundai Tucson: Electro chromic Inside Rear View Mirror / Compass Mirror Description and Operation

Hyundai Tucson (LM) 2010-2015 Service Manual / Body Electrical System / Electro chromic Inside Rear View Mirror / Compass Mirror Description and Operation

Description

The compass feature is designed to be integrated into an electro chromic interior rearview mirror.

The mirror assembly shall display a compass heading.

The compass mirror then take the sensor information to determine static field strengths and rotating field information to determine an accurate compass heading.

Specification

Item	Standard value
Rate voltage	DC 12V
Operating voltage range	DC9 ~ 16V
Operating temperature range	-30 ~ +65°C (-22 ~ 149°F)
Direction display	8
Renewal time	2 sec.

Switch Point Accuracy

The compass module shall, while compensating for the vehicle magnetic fields, until the Earth's varying magnetic fields to determine direction.

[Switch points]

Switch point	Heading ± 10°
N - NE	22.5
NE - E	67.5
E - SE	112.5
SE - S	157.5
S - SW	202.5
SW - W	247.5
W - NW	292.5
NW - N	337.5

There should be hysteresis at each switch point.

Switch points between the 8 cardinal directions, these switch points are ± 10°

Compass display interval

Compass display should be updated at every two seconds.

Function

The compass can be turned ON and OFF and will remember the last state when the ignition is cycled. To turn the display feature ON/OFF :

1.	Press and release the feature control button (A) to turn the display feature OFF.

Press and release the feature control button (A) again to turn the display back ON.

Additional options can be set with press and hold sequences of the feature control button (A) and are detailed below.

There is a difference between magnetic north and true north. The compass in the mirror can compensate for this difference when it knows the magnetic zone in which it is operating. This is set either by the dealer or by the user.

Repair procedures

Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the forward facing sensor. 3. Head a light ...

Compass Mirror Repair procedures

Adjustment Calibration procedure If the display read "C", calibrate the compass. 1. Driving the vehicle in a circle at less than 8km/h 3 times or until the compass heading appears. 2. Drivin ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Troubleshooting
Troubleshooting SymptomPossible causeRemedyHard steeringImproper front wheel alignmentExcessive turning resistance of lower arm ball jointLow tire pressureNo power assistCorrectReplaceAdjustRepair and replacePoor return of steering wheel to centerImproper front wheel alignmentCorrectPoor or rou ...

Hyundai Tucson (LM) 2010-2015 Service Manual: Line Pressure Control Solenoid Valve Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve sensor connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resistance is within the specification. Removal Replacing an on/off ...