Hyundai Tucson: Engine Control System / Crankshaft Position Sensor (CKPS) Specifications

Specification
Item
Specification
Coil Resistance (x)
774 ~ 946 [20°C (68°F)]

Crankshaft Position Sensor (CKPS) Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine ...

Crankshaft Position Sensor (CKPS) Troubleshooting
Signal waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using the ...

Other information:

Hyundai Tucson (LM) 2010-2015 Service Manual: Oil level sensor Repair procedures
Removal and Installation [For Europe] When the oil sensor signal fault occurs, refer to the DTC guide. 1. Drain the engine oil. 2. Remove the oil level sensor (A) after disconnecting the oil level sensor connector. Tightening torque: 8.8 ~ 9.8N.m (0.9 ~ 1.0kgf.m, 6.5 ~ 7.2lb-ft) ...

Hyundai Tucson (LM) 2010-2015 Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer to “Specification” ETC Motor 1. Turn the ignition switch OFF. 2. Disco ...

© 2010-2019 www.htmanual.net